articles:proxmox_span
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
articles:proxmox_span [2018/04/27 17:34] – [Create a new bridge] veera | articles:proxmox_span [2018/04/27 17:52] (current) – [Add a new interface to a VM using this bridge vmbr7] veera | ||
---|---|---|---|
Line 31: | Line 31: | ||
</ | </ | ||
+ | |||
+ | Then | ||
+ | |||
+ | < | ||
+ | systemctl restart network | ||
+ | </ | ||
+ | |||
+ | |||
+ | Basically, this creates a dumb bridge with zero bridge_ageing, | ||
+ | |||
+ | Now '' | ||
+ | |||
+ | |||
+ | ==== Add a new interface to a VM using this bridge vmbr7 ==== | ||
+ | |||
+ | Next logon to Proxmox VE and add a new sniffing interface using //Hardware -> Add -> Network Device// | ||
+ | |||
+ | Then select the new bridge for this interface as shown below | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Then go back and review the VM, there should be TWO intefaces, one for management and the other for the sniffing. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | |||
+ | ===== Configure the capture interface within the VM ===== | ||
+ | |||
+ | Now boot up the VM and you will find two adapters. | ||
+ | |||
+ | Typing '' | ||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | <note important> | ||
+ | |||
+ | |||
+ | We're done. Now, all you need to do is capture from '' | ||
+ | |||
+ | |||
+ | Hope this helps. Trisul is designed to be frugal in resource usage , we can install several such Trisul on a single Proxmox platform using this technique. | ||
+ | |||
+ | |||
+ | -end- | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
articles/proxmox_span.1524830692.txt.gz · Last modified: 2018/04/27 17:34 by veera