docker:rhel74
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
docker:rhel74 [2017/12/30 12:52] – [Install Docker CE on RHEL7.4] veera | docker:rhel74 [2017/12/30 13:01] (current) – veera | ||
---|---|---|---|
Line 7: | Line 7: | ||
===== Install Docker CE on RHEL7.4 ===== | ===== Install Docker CE on RHEL7.4 ===== | ||
- | Docker CE is not officially supported on RHEL 7.4 however you can install an earlier version quite easily from the packages released by Docker. | + | Docker CE is not officially supported on RHEL 7.4 however you can install an earlier version quite easily from the packages released by Docker. |
<code bash> | <code bash> | ||
+ | |||
yum install libtool-ltdl | yum install libtool-ltdl | ||
+ | |||
rpm -ivh https:// | rpm -ivh https:// | ||
+ | |||
rpm -ivh https:// | rpm -ivh https:// | ||
+ | |||
</ | </ | ||
- | d | + | |
+ | |||
+ | ===== Start the Docker service ===== | ||
+ | |||
+ | After installing Docker CE you need to start the service. | ||
+ | |||
+ | <code bash> | ||
+ | |||
+ | systemctl start docker | ||
+ | |||
+ | </ | ||
+ | |||
+ | |||
+ | ===== Run TrisulNSM on eth0 ===== | ||
+ | |||
+ | The following command starts the TrisulNSM Docker image with the following properties | ||
+ | |||
+ | - Captures from interface '' | ||
+ | - Stores persistent data in ''/ | ||
+ | - Names the container '' | ||
+ | |||
+ | |||
+ | <code bash> | ||
+ | |||
+ | sudo docker run --name=trisul1a | ||
+ | | ||
+ | --d trisulnsm/ | ||
+ | --interface | ||
+ | |||
+ | </ | ||
+ | |||
+ | |||
docker/rhel74.1514618524.txt.gz · Last modified: 2017/12/30 12:52 by veera