tips:netflow_troubleshooting
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
tips:netflow_troubleshooting [2020/03/19 11:20] – navaneeth | tips:netflow_troubleshooting [2020/03/19 18:13] – [2. Check if the Nodes are turned up] navaneeth | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | z====== Troubleshooting Netflow ====== | + | ====== Troubleshooting Netflow ====== |
This article explains how you can troubleshoot the following problem. | This article explains how you can troubleshoot the following problem. | ||
Line 47: | Line 47: | ||
Check if all the probes and hubs are in the Started position. | Check if all the probes and hubs are in the Started position. | ||
+ | {{: | ||
{{: | {{: | ||
Line 91: | Line 92: | ||
**No**. Add the specific port number to Netflow using Context: default → profile0 → Netflow Wizard. | **No**. Add the specific port number to Netflow using Context: default → profile0 → Netflow Wizard. | ||
+ | |||
+ | {{: | ||
<note tip>You need to restart trisul after this step.</ | <note tip>You need to restart trisul after this step.</ | ||
Line 97: | Line 100: | ||
Are the templates visible? | Are the templates visible? | ||
+ | |||
+ | {{: | ||
**Yes**. Move to next step. | **Yes**. Move to next step. |
tips/netflow_troubleshooting.txt · Last modified: 2020/03/20 15:29 by navaneeth