Trisul Network Analytics
Developer Zone

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== How to redirect Netflow to Trisul across network segments using NAT ======

In some customers, Trisul is often deployed on a separate segment from the production routers or routers in the DMZ. These sites often have a gateway device that be be used to access.  The routers can reach the gateway to export NETFLOW but cannot reach the Trisul server directly. The picture below shows how the setup is.

{{:hardware:netflow-nat.png?600|}}

This HOWTO explains how to use  Linux IPTABLES NAT to solve the issue.

<note>You may want to setup a GRE Tunnel instead to preserve the router IPs while also using the source IP of the gateway node, read "[[hardware:gretunnel|Setup GRE Tunnel]]"</note>
===== IPTABLES Port based NAT =====

**On the gateway device** you just need to run the following commands, say you want to move port 2055 to a particular IP.

==== Shutdown ufw or disable firewalld ====

since we are working directly with iptables. 

<code  bash>
# On Ubuntu
ufw disable

# On CentOS/RHEL
systemctl firewalld stop

# Make sure ip forwarding is enabled in kernel
echo 1 > /proc/sys/net/ipv4/ip_forward
</code>


==== Then setup the Port NAT ====

The following commands move port 2055 to the Trisul IP (see the diagram above) .

<code>
$ iptables -t nat -A PREROUTING -p udp --dport 2055 -j DNAT --to-destination 10.10.10.17:2055
</code>


You should now be seeing Netflow  flowing to the Trisul box.


<note important>NOTE: Do not use the MASQUERADE POSTROUTING rule, because we want to preserve the Source IP address of the original router in the netflow packets. Otherwise Trisul can  assume that the Gateway device is the router.
</note>
==== Useful commands ====

To view NAT rules with counters
''
iptables -t nat -vL

''
==== Reference ====


Forwarding and NAT  with IPTABLES : Redhat https://access.redhat.com/documentation/en-US/Red_Hat_Enterprise_Linux/4/html/Security_Guide/s1-firewall-ipt-fwd.html